Breadboard + modules
Start with the development board and breakouts. Verify rails, scan I²C, test inputs, then add LED and audio loads. Route high-current power with rated leads and terminals.
FROM A LITTLE IDEA TO REAL ELECTRONICS
See what goes where. Understand every connection. Build it one step at a time.
The assembly steps, connection map, and downloads below remain fully usable.
View the wiring map ↓03 / BENCH NOTES
The 3D lines show functional relationships. This table is the pin-to-pin connection plan. GPIO numbers are chip GPIO labels; J1/J3 references refer to the official v1.1 board headers.
| Component | From | To | Signal | Bench note |
|---|
Quantities cover one device. Add a solderless breadboard, jumper wires, multimeter, soldering tools, standoffs, and a carrier board. Confirm the exact breakout revision before purchase.
| Qty | Component / specification |
|---|
This download is a pin-configured I²C / digital-input diagnostic. It does not implement the finished clock, timer, sensor drivers, RGB protocol, or voice pipeline. It has not been compiled or tested on hardware here.
Start with the development board and breakouts. Verify rails, scan I²C, test inputs, then add LED and audio loads. Route high-current power with rated leads and terminals.
Transfer the tested connections to perfboard or a custom carrier with headers. Keep the antenna clear, sensors ventilated, and USB accessible. Measure your actual modules and mounting holes.
In KiCad, draw the full schematic, select verified footprints, place components, route power and signals, and run ERC/DRC. Review current capacity, grounding, decoupling, and enclosure fit before fabrication.
The website is a modular assembly and connection guide. Its 3D board and lines are not dimensioned CAD, routed copper, an electrical simulation, or manufacturing files. No Gerbers are supplied. The proposed wiring is not physically validated.
One power source at a time. Use a regulated, current-limited 5 V / 2 A source for standalone assembly. Disconnect USB when feeding the 5V header. Disconnect the external 5 V lead before USB programming. All GPIO signals stay at 3.3 V; the LED buffer is the explicit exception on its output side.